Acura 1994 Integra Service Manual page 1059

5 .
6 .
7 .
Rsmove the dashboard (see section 2O).
Remove the heater duct (see page 21-20) or the
evaporator lse€ page 22-26).
Rsmove the two bolts, nut and the passenger,s SRS
(}eam.
PASSEIVGER'S
SRS EEAM
Disconnect the mode control motor conngctor, and
remove the wire harness clip from the h€8ter unit.
Remove the two mounting nuts and the haater unit.
6 r 1 . 0 m m
9.8 .m (l.O kgt.m, 7.2 tbt.frl
MODE COI{TROL I,IOTOR
col{t{€cToF
8 .
8 x 1,26 mln
22 N.m 12.2 kgf.m, 18 tbt.ttl
9.
Install in the reverse order of removal, and:
a apply sealant to the grommets.
a do not int6rchange the inlet and outl€t hoses.
Make sure that the hose clamps are secure.
a loosen th€ ble6d bolt on th6 engine and r€fillthe
tadiator and coolant r€servoir with the propsr en_
gine coolant mixture (sse section 1O).
Tighten the blsed boh when all the trapped air has
6sc8p6d and engine coolant begins to flow from
it (see section 1O).
a connect all csbles and make sure they 8re properly
adiusted (see pdge 21-271.
21-23