Acura 1994 Integra Service Manual page 1061

Defroster Door Adjustment
Set the mode control switch on HEAT.
Loosen the adiusting screw.
Turn the adjusting arm to the left, as shown, so that
there will be no heat leakage from the defroster door,
Tighten the sdjusting screw. 4 .
CE]TTER AIR VEI{T
4.
Remove the four self-tapping screws and the center
air v€nt.
Install in the reverse order of removal. and adjust the
air mix control cable at the heater unit lsee page
21-27). lf necessary, adjust the heater valve cable
l s e e p a g e 2 1 - 2 7 ) .
REAR WITIDOW
DEFOGGER
swtTcH
Heater Control Panel
Replacement
Disconned the air mix control cable from the heat-
er unit lsee page 21-271.
Remove the rear window defogger switch and the
hazard warning switch.
Remove the two self-tapping screws, then pull out
the heater control panel and the center air vent. Dis-
connect the connectots, and remove the heater con-
trol panel and the center air vent.
NOTE: The locking tabs of the hazard warning
switch and heater control panel connectors are on
the bottom.
AD.'USTII{G ARM
ADJUSTI G SCREW
AIR MIX CONTROL CABLE
CENTEB AIR VE T
21-25