Acura 1994 Integra Service Manual page 1015

8 .
o .
7 .
9. Remove the nuts, then remove the hatch.
a : Nut locations, 4
Remove the uDDer anchor bolts from the tront and
rear seat belts {see pages 20-1 1 5, 'l 19), then re-
move the upper portion of the quarter pillar trim panel
(see page 20-991.
Remove the rear roof trim, then pull the rear of the
headliner down (see page 2O-99).
NOTE: Take care not to bend the headliner,
Remove the support stfut on each side while hold-
ing the hatch.
SUPPORT
STRUT
HATCH
HATCH
I x 1 . 2 5 m m
2 2 N m
12,2 kgt'm,
16 tbt.ftl
12.2 kgl.m, I
,6'y!:t ,/
NOTE:
a lf necessary, replace the support strut.
a When scrapping the suppon $rut, dispose ir as
described on page 20-149.
a lf necessary, remove the hatch hinge.
V : Solt locdlions, 4
8 x 1 . 2 5 m m
22 N.rn
12.2 kgt.m,
16 tbf.ft)
HATCH
HINGE
HATCH
1O. Installation is the reverse ot the removal procedure.
N O T E :
a lf necessary, replace any damaged clips.
a Make sure the connectors are connected properly.
a Make sure the hatch locks securely.
a Make sure the hatch opens properly.
a Adjust the hatch alignment (see page 20-148).
20-147