Call Hold Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
MWI Server Transport Type
configure voip > gateway dtmf-
supp-service supp-service-
settings > mwi-srvr-transp-type
[MWIServerTransportType]
MWI Subscribe Expiration Time
configure voip > gateway dtmf-
supp-service supp-service-
settings > mwi-subs-expr-time
[MWIExpirationTime]
MWI Subscribe Retry Time
configure voip > gateway dtmf-
supp-service supp-service-
settings > mwi-subs-rtry-time
[SubscribeRetryTime]
Subscription Mode
configure voip > sip-definition
proxy-and-registration >
subscription-mode
[SubscriptionMode]
configure voip > interface fxs-fxo
> etsi-vmwi-type-one-standard
[ETSIVMWITypeOneStandard]
configure voip > interface fxs-fxo
> bellcore-vmwi-type-one-
standard
[BellcoreVMWITypeOneStandard]
65.10.5.5

Call Hold Parameters

The call hold parameters are described in the table below.
Parameter
Version 7.2
Determines the transport layer used for outgoing SIP dialogs
initiated by the device to the MWI server.

[-1] Not Configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: When set to 'Not Configured', the value of the parameter
SIPTransportType is used.
Defines the MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 2,000,000.
Defines the subscription retry time (in seconds) after last
subscription failure.
The default is 120 seconds. The range is 10 to 2,000,000.
Determines the method the device uses to subscribe to an MWI
server.

[0] Per Endpoint = (Default) Each endpoint subscribes
separately - typically used for FXS interfaces.

[1] Per Gateway = Single subscription for the entire device -
typically used for FXO interfaces.
Determines the ETSI Visual Message Waiting Indication (VMWI)
Type 1 sub-standard.

[0] = (Default) ETSI VMWI between rings

[1] = ETSI VMWI before ring DT_AS

[2] = ETSI VMWI before ring RP_AS

[3] = ETSI VMWI before ring LR_DT_AS

[4] = ETSI VMWI not ring related DT_AS

[5] = ETSI VMWI not ring related RP_AS

[6] = ETSI VMWI not ring related LR_DT_AS
Note: For the parameter to take effect, a device reset is required.
Determines the Bellcore VMWI sub-standard.

[0] = (Default) Between rings.

[1] = Not ring related.
Note: For the parameter to take effect, a device reset is required.
Table 65-46: Call Hold Parameters
1135
65. Configuration Parameters Reference
Description
Description
Mediant 1000B Gateway & E-SBC