CHAPTER 72 Configuration Parameters Reference
[MWIExpirationTime]
'MWI Subscribe Retry Time'
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-
subs-rtry-time
[SubscribeRetryTime]
'Subscription Mode'
configure voip > sip-
definition proxy-and-
registration >
subscription-mode
[SubscriptionMode]
configure voip >
interface fxs-fxo > etsi-
vmwi-type-one-standard
[ETSIVMWITypeOneStandard]
configure voip >
interface fxs-fxo >
bellcore-vmwi-type-one-
standard
[BellcoreVMWITypeOneStandard]
Call Hold Parameters
The call hold parameters are described in the table below.
Parameter
'Enable Hold'
configure voip >
gateway dtmf-supp-
service supp-
service-settings >
hold
[EnableHold]
Parameter
Table 72-45:Call Hold Parameters
Global parameter that enables the following:
■
Analog interfaces: Call Hold feature
■
Digital interfaces: Interworking of the Hold/Retrieve
supplementary service from ISDN to SIP.
Mediant 800 Gateway & E-SBC | User's Manual
Description
Defines the subscription retry time (in seconds) after
last subscription failure.
The default is 120 seconds. The range is 10 to
2,000,000.
Determines the method the device uses to subscribe to
an MWI server.
■
[0] Per Endpoint = (Default) Each endpoint
subscribes separately - typically used for FXS
interfaces.
■
[1] Per Gateway = Single subscription for the entire
device - typically used for FXO interfaces.
Determines the ETSI Visual Message Waiting
Indication (VMWI) Type 1 sub-standard.
■
[0] = (Default) ETSI VMWI between rings
■
[1] = ETSI VMWI before ring DT_AS
■
[2] = ETSI VMWI before ring RP_AS
■
[3] = ETSI VMWI before ring LR_DT_AS
■
[4] = ETSI VMWI not ring related DT_AS
■
[5] = ETSI VMWI not ring related RP_AS
■
[6] = ETSI VMWI not ring related LR_DT_AS
Note: For the parameter to take effect, a device reset is
required.
Determines the Bellcore VMWI sub-standard.
■
[0] = (Default) Between rings.
■
[1] = Not ring related.
Note: For the parameter to take effect, a device reset is
required.
Description
- 1314 -