User's Manual
53.11.5.2
Call Waiting Parameters
The call waiting parameters are described in the table below.
Parameter
Web/EMS: Enable Call
Waiting
[EnableCallWaiting]
EMS: Send 180 For Call
Waiting
[Send180ForCallWaiting]
53.11.5.3
Call Forwarding Parameters
The call forwarding parameters are described in the table below.
Parameter
Web: Enable Call
Forward
[EnableForward]
53.11.5.4
Call Hold Parameters
The call hold parameters are described in the table below.
Parameter
Web/EMS: Enable Hold
[EnableHold]
Version 6.6
Call Waiting Parameters
Enables the Call Waiting feature.
[0] Disable
[1] Enable (Default)
If enabled and the device initiates a Tel-to-IP call to a destination that
is busy, it plays a call waiting ringback tone to the caller. The tone is
played only if the destination returns a 182 "Queued" SIP response.
Note: The device's Call Progress Tones (CPT) file must include a Call
Waiting ringback tone.
Determines the SIP response code for indicating Call Waiting.
[0] = (Default) Use 182 Queued response to indicate call waiting.
[1] = Use 180 Ringing response to indicate call waiting.
Call Forwarding Parameters
Enables the Call Forwarding feature.
[0] Disable
[1] Enable (Default)
Note: To use this service, the devices at both ends must support this
option.
Call Hold Parameters
Enables interworking of the Hold/Retrieve supplementary service from
PRI to SIP.
[0] Disable
[1] Enable (default)
Notes:
To support interworking of the Hold/Retrieve supplementary service
from SIP to ISDN (Euro ISDN), set the parameter EnableHold2ISDN
to 1.
This parameter can also be configured in an IP Profile.
53. Configuration Parameters Reference
Description
Description
Description
757
Mediant 3000