Gateway And Ip-To-Ip Parameters; Fax And Modem Parameters - AudioCodes Mediant 500 E-SBC User Manual

User's Manual

54.10 Gateway and IP-to-IP Parameters

54.10.1 Fax and Modem Parameters

The fax and modem parameters are described in the table below.
Parameter
Web: Fax Transport Mode
EMS: Transport Mode
CLI: fax-transport-mode
[FaxTransportMode]
EMS: V34 Transport Method
CLI: V34-fax-transport-type
[V34FaxTransportType]
Web: V.21 Modem Transport Type
EMS: V21 Transport
CLI: V21-modem-transport-type
[V21ModemTransportType]
Web: V.22 Modem Transport Type
EMS: V22 Transport
CLI: V22-modem-transport-type
[V22ModemTransportType]
Web: V.23 Modem Transport Type
EMS: V23 Transport
CLI: V23-modem-transport-type
[V23ModemTransportType]
Web: V.32 Modem Transport Type
EMS: V32 Transport
Version 6.8
Table 54-37: Fax and Modem Parameters
Determines the fax transport mode used by the device.

[0] Disable = transparent mode

[1] T.38 Relay (default)

[2] Bypass

[3] Events Only
Note: This parameter is overridden by the parameter
IsFaxUsed. If the parameter IsFaxUsed is set to 1 (T.38 Relay)
or 3 (Fax Fallback), then FaxTransportMode is always set to 1
(T.38 relay).
Determines the V.34 fax transport method (whether V34 fax falls
back to T.30 or pass over Bypass).

[0] = Transparent

[1] = (Default) Relay

[2] = Bypass

[3] = Transparent with Events
Note: To configure V34FaxTransportType to 1 (i.e., fax relay),
you also need to configure FaxTransportMode to 1 (fax relay).
Determines the V.21 modem transport type.

[0] Disable = (Default) Transparent.

[2] Enable Bypass

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 304.
Determines the V.22 modem transport type.

[0] Disable = Transparent.

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 304.
Determines the V.23 modem transport type.

[0] Disable = Transparent.

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 304.
Determines the V.32 modem transport type.

[0] Disable = Transparent.
791
54. Configuration Parameters Reference
Description
Mediant 500 E-SBC