Setting The Tool Up Move - GRAPHTEC FC8000 Series User Manual

8 -
6

Setting the Tool Up Move

When the plotter receives a command to move the tool in the raised status to several coordinates from the
control PC, "TOOL UP MOVE" setting decides either to move to each of the coordinates in order it receives,
or directly to the last coordinate.
There are following 2 settings for "TOOL UP MOVE".
ENABLED: If several coordinates are received continuously, it will move to each in order it is received.
DISABLED: If several coordinates are received continuously, it will directly move to the last coordinate
received.
Cutting time can be reduced if it is set to "DISABLED", if the time to move the tool in raised status is
wasteful.
Supplement
Setting for the TOOL UP MOVE is maintained even if the power is turned off.
Operation
Press the [MENU] key.
1
MENU screen is displayed.
Press the [1] key (TOOL).
2
TOOLS SETTINGscreen (1/3) is displayed.
Press the POSITION (¡ã ) key.
3
TOOLS SETTINGscreen (3/3) is displayed.
Press the [3] key (TOOL UP MOVE).
4
TOOL UP MOVE setting screen is displayed.
Next page
POSITION
8-11