When Selecting Roll-2 Rear Set (Roll-2 Front Set) By Pressing The [2] Key; When Pressing The [3] Key To Select Sheet; To Change The Loading Method - GRAPHTEC FC8000 Series User Manual

When Selecting ROLL-2 REAR SET (ROLL-2 FRONT SET) by Pressing
the [2] Key
Select this when you have loaded a roll of media and you wish to start cutting
or plotting from a point beyond the leading edge. Only the width of the roll
media is detected.

When pressing the [3] key to select SHEET

Select this when a cut sheet has been loaded. The leading edge, trailing edge,
and width of the sheet are detected.
After the media is detected, the plotter is ready to receive data
2
for cutting or plotting. This status is called "READY status" of
the default screen. If the interface or command settings have
not been made, make these settings before sending the data.
If the settings have been made, tool adjustment is performed.
When the pen adjustments have been made, the plotter is
ready to start cutting. Send the cutting or plotting data from the
application software.

To Change the Loading Method

Direction to set the roll media is changed to change the loading method.
Default is rear loading.
Press the [MENU] key in the default screen.
3
MENU screen is displayed.
Press the [4] key (MEDIA).
4
MEDIA setting screen (1/2) is displayed.
Next page
2-21