Automatically Cross Cut - GRAPHTEC FC8000 Series User Manual

Automatically Cross Cut

will automatically cross cut after cutting when the cutting is done with provided software. See the User Guide
It
for the provided software for details.
It will perform a cross cut with timeout or SEPARATOR command even if the CROSS CUT command is not
received when the AP mode is set on. Cross cut position will be "SPACE REAR"added behind the cut area. See
the User Guide for the "Cutting Plotter Controller" for details.
See the "Apparel (AP) Mode" for details about the settings of space rear and apparel (AP)
P .4-14
mode.
CAUTION
Do not place your hand where the blade might move while it is cutting. Y ou may be injured.
3-16