Assigning Tool Number - GRAPHTEC FC8000 Series User Manual

Assigning Tool Number

The tool number to use can be set for each of the 8 TOOL
CONDITION No. Tool 1 will use the tool attached to the backward
of the tool holder (for half cutting), tool 2 will use the tool attached
to the pen station, and tool 3 will use the tool attached to the
forward of the tool holder (for cutting out).
Operation
Press the [CONDITION] key.
1
CONDITION setting screen (1/3) is displayed.
Press the POSITION (¡å ) key.
2
CONDITION setting screen (2/3) is displayed.
Press the [3] key (ASSIGN TOOL).
3
ASSIGN TOOL setting screen is displayed.
Press the POSITION (? ? ) key and select the CONDITION No.
4
Press the [1], the [2], or the [3] key and select the tool number
5
to set.
Confrm the setting and press the [ENTER] key (SET).
6
Setting will be set, and it will return to CONDITION screen (2/3).
Next page
Supplement
l This setting is maintained even if the power is
turned off.
l Physical pen 2 can be set only when the tool is
mounted on the pen station on the 2-pen plotter.
l See "Attaching to T ool Holder (Option)"
Only the plotting pens can be mounted on the pen
station. Do not mount the cutter pens.
POSITION
Supplement
l T ool number [2] can be set only when the tool is
mounted on the pen station on the 2-pen plotter.
l Only [1] can be set when using the pouncing
tool.
Supplement
It will return to CONDITION screen (2/3) without
changing the settings when you press the [4] key
(CANCEL).
14-9
P .14-7 and "Attaching to the Pen Station"
P .14-8 for mounting of the tools.
CAUTION