When The Media Width Is 100 To 160Mm; When The Media Width Is 160 To 540 Mm Or Exceeds 540 Mm - GRAPHTEC FC8000 Series User Manual

Position the media and the push rollers to correspond with the
3
width of the media.

When the Media Width is 100 to 160mm

Position the two right-hand push rollers so that they are above the long grit
roller at the right edge of the plotter when the plotter is viewed from the front.
Position the media so that its left edge is aligned with the left edge of the grit
roller, and then position the push rollers over both edges. Move any push
rollers that are not used to the standby position.
Media
sensor

When the Media Width is 160 to 540 mm or Exceeds 540 mm

See step 4 of rear loading.
Pull the media taut to make sure that there is no slack in the
4
conveyance path, and then raise the media set lever to lower
the push rollers. If you align the right edge of the sheet with
the guides on the platen, the sheet can be loaded so that it is
straight.
Origin point
Push roller
Media
Grit roller
Supplement
l The media must be at least 125 mm in length.
l The media must always be positioned over the
media sensor.
l See "Aligning the Push Rollers"
about the position of the push rollers.
l See "Standby the Push Roller"
the standby position.
Media
2-12
P .2-13
P .2-13
Align with
these
holes
about