For Between Tool 1 And 3 - GRAPHTEC FC8000 Series User Manual

Confrm the setting and press the POSITION (? ) key
14
(PREVIOUS).
X AXIS ALIGNMENT is selected and return to the TOOL OFFSET
ADJ. screen.
Press the [4] key (Y).
15
Y AXIS ALIGNMENT setting screen is displayed.
Press the POSITION (¡ã¡å ) key to increase or decrease the
16
value to set the difference in Y axis direction measured in step
11.
Confrm the setting and press the POSITION (? ) key
17
(PREVIOUS).
Y AXIS ALIGNMENT is selected and return to the TOOL OFFSET
ADJ. screen.
Repeat steps 7 to 17 until there is no difference.
18
Confrm the distance and press the [ENTER] key (SET).
19
Setting will be set, and it will return to TOOLS SETTINGscreen (1/3).
Press the [MENU] key.
20
It will return to default screen.

For between tool 1 and 3

Position adjustment is performed by entering the compensation value if there is a difference between tool 1
(tool attached to the backward of the tool holder) and tool 3 (tool attached to the forward of the tool holder).
Operation
Mount either the cutter plungers or the plotting pens on the tool
1
1 (backward of the tool holder) and turn on the power.
Press the [MENU] key in READY status.
2
MENU screen is displayed.
Next page
POSITION
POSITION
POSITION
When pushing the tool holder with your fingers,
the blade tip may be protruding. T ake care not to
cut your fingers.
14-12
CAUTION