Rear View
Media lock
Media set lever......................Used to raise or lower the Push rollers during the loading or unloading of media.
Push roller hold-down force switching lever
..............................................Used to switch between the three push roller forces (outside push rollers only has
AC line inlet ...........................Inlet where the power cord is connected.
Media stocker........................Used to carry roll media and ensure its proper rotation.
Stock rollers...........................A media roll is placed on these rollers.
Media lock .............................Used to prevent the stock rollers from rotating when the media roll has been
USB interface connector .......Used to connect the plotter to the computer with a USB interface cable.
Network interface connector ....Used to connect the plotter to the computer with a network interface cable.
RS-232C interface connector
..............................................Used to connect the plotter to the computer with a RS-232C interface cable.
Push roller hold-down force switching lever
2 forces of strong and medium).
placed on top of them. The media lock ensures that the media is pulled straight
out from the roll.
(Factory-installed option)
1-4
Stock rollers
Media set lever
USB interface
RS-232C interface
Network interface (Factory-installed option)
AC line inlet
Media stocker