GRAPHTEC FC8000 Series User Manual page 93

It will copy in following order when COORDINATE AXES ROTATION is set.
<For rear loading/sheet>
Copy origin point
First cut
Origin point
Operation
Create one data you want to copy.
1
Cutting data is stored in the buffer memory.
Press the POSITION (¡ã¡å ? ? ) key and move the tool carriage
2
to the position to copy.
Press the [COPY] key.
3
COPY MODE screen is displayed.
Press the [1] key (NUMBER OF COPIES).
4
NUMBER OF COPIES setting screen is displayed.
Press the POSITION (¡ã¡å ) key and increase or decrease the
5
setting value.
Next page
Second
copy
First copy Third copy
Copy
space
Copy space
Fifth copy Sixth copy
Supplement
Fourth
For the front loading model, rotate the above
copy
figure 180 degrees.
POSITION
Supplement
l "NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
"COPY MODE BUFFER FULL! CANNOT
l
COPY" is displayed if the data sent was bigger
than what can be stored in the buffer memory.
Supplement
Number of copies can be set from 1 to 100, as
POSITION
much as it can fit in the media set on the printer.
4-10