GRAPHTEC FC8000 Series User Manual page 248

Press the [2] key (TOOL 1-2).
6
It is set to adjust between the TOOL 1-2 and return to TOOL
OFFSETADJ. screen.
Press the [2] key (TEST PATTERN).
7
T ool position move screen is displayed.
Press the POSITION (¡ã¡å ? ? ) key to move the tool carriage to
8
the location to draw "+". Move at least 50 mm inside the cutting
are for both X and Y .
Confrm the position of the tool and press the [ENTER] key.
9
T ool 1 will plot the "+". Screen prompting to change the tool is
displayed once the plotting is completed.
Set the cutter plunger or plotting pen to the tool 2 (pen station)
10
and press the [ENTER] key.
T ool 2 will plot the "+" and return to the TOOL OFFSETADJ.
screen once the plotting is completed.
Using the "+" plotted by tool 1, measure the distance to the "+"
11
plotted by tool 2.
T ool 2
Press the [3] key (X).
12
X AXIS ALIGNMENT setting screen is displayed.
Press the POSITION (¡ã¡å ) key to increase or decrease the
13
value to set the difference in X axis direction measured in step
11.
Next page
T ool 1
Y mm
X
Y
X mm
Supplement
It will return to TOOL OFFSET ADJ. screen
without changing the settings when you press the
POSITION (? ) key (CANCEL).
Supplement
l It will return to TOOL OFFSET ADJ. screen by
pressing the [4] key (CANCEL).
POSITION
l Speed of movement will become faster by
pressing the [FAST] key and POSITION key
simultaneously.
Supplement
T ool condition 1 will be used with tool 1.
Supplement
T ool condition 2 will be used with tool 2.
POSITION
14-11