GRAPHTEC FC8000 Series User Manual page 136

Press the POSITION (¡ã¡å ? ? ) key and move the tool carriage
2
to the area to start scanning of the registration mark.
MARK TYPE1
Point
4
Point 1
(point to make
origin point)
Point
3
the tool inside this
area
Confrm the position of the tool, and if it is OK, press the [ENTER]
3
key (SET).
Registration marks are scanned automatically. DISTANCE entry screen is
displayed once the scanning is completed.
Press the POSITION (¡ã¡å ) key and increase or decrease the
4
setting value.
Confrm the setting and press the [ENTER] key (SET).
5
Adjustment by scanning the registration mark is completed, and it will return
to default screen.
Point
2
Mode the tool inside this
area
POSITION
MARK TYPE2
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
Point
Point
2
4
Point 1
(point to make
origin point)
Point
3
POSITION
5-35
Supplement
Supplement
Scan the registration marks in accordance
l
with the setting of the MARK DISTANCE (see
"Setting Mark Distance" P .5-12
It will return to ARMS setting screen (1/4)
l
without scanning when you press the [4] key
(CANCEL).
Supplement
l Measured distance is displayed in the top line in
the DISTANCE input screen. Input value (initially
same as measured value) is displayed under
that.
l If the input value is not changed, it will assume
that there is no difference between measured
distance and the distance in the data.
l Digits of settings can be changed by pressing
the [FAST] key.
Supplement
It will return to ARMS setting screen (1/4)
l
without changing the settings when you press
the POSITION (? ) key (CANCEL).
Distance input screen for point 3 is displayed if
l
it is set to 3POINTS or more, so repeat steps 4
and 5 to set.
).