Confirm The Cutting Data - GRAPHTEC FC8000 Series User Manual

13 -
4

Confirm the Cutting Data

Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the
transmission of cutting data is performed correctly.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. T ool carriage will start to move
immediately after selecting to print the dump list.
Supplement
There may be a difference in the RS-232C transmission condition or the command setting when the printed output and the display of
transmission data does not match. Check the transmission condition and the command.
Operation
Set a media larger than A4 size.
1
Set the pen tool to the tool carriage and select the condition
2
where the pen tool is set.
Press the [MENU] key.
3
MENU screen is displayed.
Press the POSITION (? ) key (TEST).
4
TESTmenu screen is displayed.
Press the [3] key (START DATA DUMP).
5
DATA DUMP start screen is displayed.
Next page
Supplement
See "Loading Media (Paper or Marking Film)"
P .2-6
Supplement
See "Attaching a T ool"
pen tool.
POSITION
13-19
for loading the media.
P .2-4 for setting the