2-Pen Assignment (Switching The Tools); Attaching To Tool Holder - GRAPHTEC FC8000 Series User Manual

14 -
2-Pen Assignment (Switching the
3
Tools)

Attaching to Tool Holder

The 2-pen unit is a factory-installed option. It cannot be retrofitted.
Operation
Loosen the tool holder screw.
1
While pushing the tool holder in the upward direction, push the
2
tool all the way into the holder until its fange contacts the upper
part of the holder.
Upper part of
tool holder
Next page
Flange
For half cutting
(backward)
For cutting out
(forward)
14-7
Supplement
See "Attaching a T ool" P .2-4
tighten the screws on the tool holder.
CAUTION
When pushing the tool holder with your fingers,
the blade tip may be protruding. T ake care not to
cut your fingers.
Supplement
l The forward position of the tool is used for the
cutting out mainly, and the backward position is
used for the half cutting mainly.
Cutting out means that the media is cut out
l
completely.
Half cutting means that only the marking flm is
l
cut out, leaving the backing sheet uncut.
l See "What is Cutting Plotter?" in Setup Manual
for structure of the marking flm.
for how to