To Make 3 Cuts With Set Value And ±1 Of Set Value - GRAPHTEC FC8000 Series User Manual

To make 3 cuts with set value and ±1 of set value
Operation
Load the media for test cutting in the plotter.
1
Press the [CONDITION] key in the default screen.
2
CONDITION screen (1/3) is displayed.
Press the POSITION (? ) key (CUT TEST).
3
CUT TESTscreen is displayed.
Press the POSITION (¡ã¡å ? ? ) key the tool carriage to the
4
location you wish to perform the test cutting.
Press the [1] key (FORCE).
5
3 cutting test patterns are cut, with current FORCE in the center, and 1 each
of FORCE increased and decreased for 1.
Press the [ENTER] key after completion.
6
It will return to CUT TESTmenu screen.
Press the [2] key (CUTTER OFFSET).
7
3 cutting test patterns are cut, with current CUTTEROFFSETin the center,
and 1 each of CUTTEROFFSETincreased and decreased for 1.
Press the [ENTER] key after completion.
8
It will return to CUT TESTmenu screen.
Press the [CONDITION] key.
9
It will return to the default screen.
Supplement
It will return to CONDITION screen (1/3) by
pressing the [4] key (CANCEL).
POSITION
When the [1] key (FORCE) is pressed, the tool
carriage will start moving, so take care not to cut
your fingers.
When the [2] key (CUTTER OFFSET) is pressed,
the tool carriage will start moving, so take care not
to cut your fingers.
2-35
CAUTION
CAUTION