Cross Cut Manually - GRAPHTEC FC8000 Series User Manual

Cross Cut Manually

is cross cut at the position 15 mm behind the last cut position.
Media
If the cutting was very small, cross cut will be made at 40 mm including the cutting itself.
is possible to cut off the roll media at desired position by cross cutting after manually moving the media using
the POSITION (¡ã¡å ) key.
CAUTION
Do not place your hand where the blade might move. Y ou may be injured.
Operation
Press the [CROSS CUT] key in the READY status.
1
CROSS CUT screen is displayed.
Press the [1] key (CUT).
2
Media is cross cut.
15 mm
Min. 40 mm
3-15
Supplement
It will return to default screen without cross cut by
pressing the [2] key (CANCEL).