Turning On The Power - GRAPHTEC FC8000 Series User Manual

2 -
5

Turning on the Power

Turning on the power of the plotter.
Operation
Check that the power switch is turned off (the " " side is
1
pressed down).
Connect one end of the provided power cord to the FC8000 AC
2
line inlet and the other end to an electrical socket of the rated
supply voltage. Make sure that the FC8000 is grounded using
the 2/3 prong adapter for the outlet that is not 2 pin socket.
Turn on the FC8000 by pressing the "|" side of the switch. The
3
control panel POWER lamp lights.
If media has not been loaded, the frmware version number is
4
displayed, followed by a prompt to load media.
Media set lever raised
u
Media set lever lowered
2-16
Supplement
This screen is described as "default screen" in
l
this document.
Settings such as initial media feed speed and
l
communication conditions can be performed.