GRAPHTEC FC8000 Series User Manual page 138

Press the POSITION (¡ã¡å ? ? ) key and move the tool carriage
4
to the next area to start scanning of the registration mark.
Registration mark scan area
MARK TYPE1
Point 4 Point 2
Point 1
(point to make
origin point)
Point 3
the tool inside this
area
Confrm the position of the tool, and if it is OK, press the [ENTER]
5
key.
Registration marks are scanned. A message to move to next registration
mark position is displayed once the scanning is completed. Repeat steps 4
and 5 following the message in that case.
DISTANCE entry screen is displayed once the registration mark is scanned.
Press the POSITION (¡ã¡å ) key and increase or decrease the
6
setting value.
Confrm the setting and press the [ENTER] key (SET).
7
Adjustment by scanning the registration mark is completed, and it will return
to default screen.
POSITION
MARK TYPE2
Point 4 Point 2
Point 1
(point to make
origin point)
Point 3
Move the tool inside this
area
POSITION
5-37
Supplement
Left figure is for 4POINTS. Size and position of the
registration scan start area is same for 2POINTS
or 3POINTS.
Supplement
l Repeat steps 4 and 5 if a message prompting to
move to next registration mark is displayed.
l Numbers to repeat steps 4 and 5 depends
on the number of the registration marks to be
scanned. Follow the instruction displayed on the
screen.
It will scan and return to ARMS setting screen
l
(1/4) when the [4] key is pressed.
Supplement
l Measured distance is displayed in the top line in
Supplement
the DISTANCE input screen. Input value (initially
same as measured value) is displayed under
l Numbers to repeat steps 4 and 5 depends on
that. the number of registration marks to be scanned.
Follow the displayed message.
If the input value is not changed, it will assume
l
l that there is no difference between measured It will return to ARMS setting screen (1/4)
distance and the distance in the data. canceling settings and adjustment when you
press the [4] key.
l Digits of settings can be changed by pressing
the [FAST] key.
Supplement
l It will return to default screen without changing
the settings when you press the POSITION (? )
key (CANCEL).
l Distance input screen for point 3 is displayed if
it is set to 3POINTS or more, so repeat steps 6
and 7 to set.