GRAPHTEC FC8000 Series User Manual page 162

Press the POSITION (¡ã¡å ) key and set the UP MODE.
11
Confrm the setting, and press the POSITION (? ) key
12
(PREVIOUS).
It will return to UP MODE CUT LINE PATTERN setting screen.
If the "USER" is chosen in step 8, press the [3] key (CUT) and
13
the [4] key (UP) to set the cut length and tool up length. Follow
steps 10 to 12 for this operation.
Confrm the setting and press the [ENTER] key (SET) in the
14
CUT LINE PATTERN setting screen.
Setting will be set, and it will return to CONDITION screen (2/3).
Press the [CONDITION] key.
15
It will return to the default screen.
Supplement
Value set here will be the cut force for the uncut
l
POSITION
part of the perforated lines. T oll will be raised
when set to "UP".
Normally, input the smaller value than the
l
FORCE for cutting to make it half cutting.
POSITION
Supplement
l If the TYPE No. 0-7 is selected in step 8, CUT L
and UP L is only displayed, and not possible to
change. Skip this step, and proceed.
l Range possible to set for the CUT L is 0.05 mm
to 100.0 mm.
l Range possible to set for the UP L is 0.05 mm
to 10.0 mm.
l Digits of settings can be changed by pressing
the [FAST] key.
Supplement
It will return to CONDITION screen (3/3) without
changing the settings when you press the
POSITION (? ) key (CANCEL).
7-17