GRAPHTEC FC8000 Series User Manual page 65

Press the [1] key (BLADE LENGTH TARGET).
8
BLADE LENGTH TARGET screen is displayed.
Press the POSITION (¡ã¡å ) key and increase or decrease the
9
setting value.
Confrm the settings and press the POSITION (? ) key
10
(PREVIOUS).
BLADE LENGTH TARGE is set and it will return to the BLADE
LENGTH setting screen.
Press the [2] key (CHECK).
11
The amount and direction to turn the adjustment knob is displayed.
Turn the blade-length adjustment knob and adjust the cutter
12
blade length.
[2] Current blade length is displayed by pressing the [2] key
(CHECK), so adjust the blade length until it matches the
thickness of the media.
Press the [3] key (END).
13
Adjustment is completed and it will return to CONDITION screen (3/3).
Press the [CONDITION] key.
14
It will return to default screen.
POSITION
POSITION
Supplement
"T" is the target value of the blade length, and "H"
is the current blade height (amount).
Depending on the loaded media, the blade
might sink in to the media, making accurate
measurement impossible.
2-38
CAUTION