Error Messages In Hp-Gl Command Mode - GRAPHTEC FC8000 Series User Manual

Error Messages in
any of the following command errors occur, they are nearly always caused by following 2 reasons.
If
1. The configuration regarding the output device in the application software has changed.
2. The plotter's interface conditions have changed.
Perform following if these are the cause of the problem.
1. Reconfigure the output device of the application software to the plotter.
2. Reconfigure the plotter's interface conditions.
Error
LCD Display
Displayed
E03001
E03002
E03003
E03005
E03006
E03007
E03010
E03011
E03012
HP-GL Command Mode
Cause
An unrecognizable instruction was Execute a recognizable command.
executed.
Wrong number of parameters
were specifed.
An unusable parameter was
executed.
An unusable character set was
specifed.
The data being input exceeds
the capacity of the plotter's
downloadable character buffer,
polygon buffer, etc.
Coordinates of command
specifed out of cutting area.
Other output command was
executed while executing an
output command.
An invalid byte was received after
ESC code.
Invalid byte was received within
device control command.
13-7
Solution
Execute the command with the
correct number of parameters.
Execute a recognizable parameter.
Specify usable character set.
Execute coordinates within the
cutting area.
Adjust the buffer size.
Check the program.
Check the program.
Check the program.