GRAPHTEC FC8000 Series User Manual page 250

Press the [1] key (TOOL).
3
TOOLS SETTINGscreen (1/3) is displayed.
Press the [2] key (TOOL OFFSET ADJ.).
4
TOOL OFFSETADJ. setting screen is displayed.
Press the [2] key (TEST PATTERN).
5
T ool position move screen is displayed.
Press the POSITION (¡ã¡å ? ? ) key to move the tool carriage to
6
the location to draw "+". Move at least 50 mm inside the cutting
are for both X and Y .
Confrm the position of the tool and press the [ENTER] key.
7
T ool 1 will plot the "+". Screen prompting to change the tool is
displayed once the plotting is completed.
Set the cutter plunger or plotting pen to the tool 3 (forward of the
8
tool holder) and press the [ENTER] key.
T ool 3 will plot the "+" and return to the TOOL OFFSETADJ.
screen once the plotting is completed.
Next page
Supplement
It will return to TOOLS SETTING screen (1/3)
without changing the settings when you press the
POSITION (? ) key (CANCEL).
Supplement
l It will return to TOOL OFFSET ADJ. screen by
pressing the [4] key (CANCEL).
POSITION
l Speed of movement will become faster by
pressing the [FAST] key and POSITION key
simultaneously.
Supplement
T ool condition 1 will be used with tool 1.
Supplement
T ool condition 3 will be used with tool 3.
14-13