How To Use Control Panel; Control Keys; Menu Keys; Indicator Lamp - GRAPHTEC FC8000 Series User Manual

2 -
6

How to Use Control Panel

This section explains the function of lamps and keys on the control panel.
USER 1 lamp
Screen (LCD)

Control Keys

POSITION (¡ã , ¡å , ? , ? ) keys.......There are following functions depending on the operation.
FAST ......................... The tool carriage or the media will move faster when it is pressed simultaneously with
CROSS CUT ............. It will cut off the media that has finished cutting.
STOP ........................ Cutting operation will stop immediately when the [STOP] key is pressed while cutting.
ORIGIN .....................It will set the current position as an origin point.
COPY ........................Copy of data in the buffer memory is output.

Menu Keys

MENU .......................It will switch to the MENU mode. MENU lamp is lit in the MENU mode.
CONDITION ............. It will display the screen to set the tool conditions.
1, 2, 3, 4 ...................Select the menu number displayed in the screen.
ENTER ......................It will define the settings.

Indicator Lamp

MENU lamp ..............Green lamp is lit while in MENU mode.
USER 1, 2 lamp .........The lamp for selected user will lit.
[2] key CROSS CUT
USER 2 lamp [1] key
[3] key [4] key
Move the tool carriage and media. It will move specified distance (see
"Setting of Step Movement Distance"
and continuously move when it is pressed down. It will select the menu when
¡ã , ¡å , ? , or ? are displayed in the menu on the screen.
POSITION key. It will work as a menu key when it is displaying "F"on the screen.
You can reset the media by pressing the [STOP] key while cutting when the media has
shifted.
The plotter is reset by pressing the [ENTER] key and the [ORIGIN] key simultaneously in
the first screen of the MENU mode (MENU screen).
It will go into MENU mode if it is pressed once, and MENU mode will be turned off when it
is pressed again.
Different function are set in the MENU mode.
Data received while in the MENU mode will be stored in the data buffer.
The plotter is reset by pressing the [ORIGIN] key and this key simultaneously in the first
screen of the MENU mode (MENU screen).
It will display current cutting area when the [ENTER] key is pressed in READY status.
The lamp is lit when the user priority is set to "Key, Controller". It will flash when it is set to
"Key only".
[MENU] key
key
[FAST] key POSITION
(¡ã , ¡å , ? , ? ) key
2-17
MENU lamp [STOP] key
[ORIGIN] key
[COPY] key
[CONDITION] [ENTER] key
key
P .3-4 ) when it is pressed once,