Enabling/Disabling 1/2 Pen Check (Check Tool) - GRAPHTEC FC8000 Series User Manual

Enabling/Disabling 1/2 Pen Check (CHECK TOOL)

It is possible to disable the check if the tool is mounted on the pen
station at the media detection. It can be set back to enabled from
here too. Make sure to set the plotting pen to the pen station at the
power up when it is set to DISABLED.
Operation
Mount either the cutter plungers or the plotting pens and turn on
1
the power.
Press the [MENU] key in the default screen.
2
MENU screen is displayed.
Press the POSITION (¡å ) key (ADV).
3
ADVANCE setting screen (1/3) is displayed.
Press the POSITION (¡å ) key.
4
ADVANCE setting screen (2/3) is displayed.
Press the [4] key (TOOL CHECK).
5
TOOL CHECK setting screen is displayed.
Press the [1] key (ENABLED) or the [2] key (DISABLED).
6
Confrm the setting and press the [ENTER] key (SET).
7
Setting will be set, and it will return to ADVANCE setting screen (2/3).
Press the [MENU] key.
8
It will return to the default screen.
Supplement
l This setting is maintained even if the power is
turned off.
l This menu is not displayed on standard
equipment.
Pen station is made for plotting pens only. Do not
mount the cutter pens.
POSITION
POSITION
Supplement
[4] is displayed only when there is a plotting pen
mounted on the pen station.
Supplement
It will return to TOOL setting screen without
changing the settings when you press the
POSITION (? ) key (CANCEL).
14-16
CAUTION