GRAPHTEC FC8000 Series User Manual page 86

Press the POSITION (¡å ) key.
3
AREA PARAMETERSsetting screen (2/2) is displayed.
Press the [1] key (AREA).
4
LOWER LEFT setting screen is displayed.
Press the POSITION (¡ã¡å ? ? ) key and move the tool carriage
5
to the position to be the lower left of the AREA.
Press the [ENTER] key (SET) once the tool carriage is in
6
correct position.
Setting will be set, and UPPERRIGHT setting screen is displayed.
Press the POSITION (¡ã¡å ? ? ) key and move the tool carriage
7
to the upper right position of the AREA.
Press the [ENTER] key (SET) once the tool carriage is in
8
correct position.
Setting will be set, and it will return to AREA parameter screen (2/2).
Press the [MENU] key.
9
It will return to default screen.
POSITION
Supplement
Coordinate value displayed here is the distance
l
to the tool carriage from the origin point.
Press [1] key (DEFAULT) if the cutting are is not
l
to change.
POSITION
POSITION
Supplement
It will return to AREA parameter screen (2/2)
without changing the settings when you press the
[4] key (CANCEL).
4-3