No Estack Command-Switch - Allied Telesis AT-8100L/8 User Manual

NO ESTACK COMMAND-SWITCH

Syntax
no estack command-switch
Parameter
None
Mode
Global Configuration mode
Description
Use this command to return the enhanced stacking mode on the switch to
member switch from command switch. This command has the following
guidelines:
 The default setting for the enhanced stacking mode on the switch
is member. So you would only use this command if you set the
mode to command mode and now want to return it to member
mode.

Enhanced stacking must be activated on the switch for you to use
the command. To activate enhanced stacking, refer to "ESTACK
RUN" on page 434.
 You cannot use this command on a switch accessed through
enhanced stacking. This command can only be used from a local
or remote management session of the switch.
To configure the switch as a command switch, refer to "ESTACK
COMMAND-SWITCH" on page 433.
Confirmation Command
"SHOW ESTACK" on page 440
Example
This example returns the switch's stacking status to member switch:
awplus> enable
awplus# configure terminal
awplus(config)# no estack command-switch
AT-8100 Switch Command Line User's Guide
435