Displaying An Ipv4 Management Address And Default Gateway - Allied Telesis AT-8100L/8 User Manual

Fast ethernet switches at-8100 series management software command line interface user’s guide alliedware plus version 2.2.5

Hide thumbs Also See for AT-8100L/8:

Table of Contents

Displaying an

Default Gateway

--------------------------------------------------------------------

--------------------------------------------------------------------

--------------------------------------------------------------------

awplus> enable

awplus# configure terminal

awplus(config)# no ip route 0.0.0.0/0 149.121.43.23

The easiest way to view the IPv4 management address and default

gateway address of the switch is with the SHOW IP ROUTE command. It

displays both addresses at the same time. The command is found in the

Privileged Exec mode, as shown here:

awplus# show ip route

See Figure 68 on page 301 for an example of the information. The

management IPv4 address of the switch is displayed in the first entry in the

table and the default gateway address, if assigned to the switch, in the

second entry. Figure 68 displays an example of the information.

255.255.255.0

Figure 68. SHOW IP ROUTE Command

The columns in the display are defined in Table 29 on page 326.

To view only the management IP address, use the SHOW IP INTERFACE

command, also in the Privileged Exec mode:

awplus# show ip interface

Here is an example of the information from the command.

123.94.146.72

Figure 69. SHOW IP INTERFACE Command

For definitions of the columns: See "SHOW IP INTERFACE" on page 325.

AT-8100 Switch Command Line User's Guide

Show Quick Links

Table of Contents