Configuring The Command Switch - Allied Telesis AT-8100L/8 User Manual

Configuring the Command Switch

awplus> enable
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan 12 name Tech_Support
awplus(config-vlan)# exit
awplus(config)# interface port1.0.18-port1.0.22
awplus(config-if)# switchport mode access
awplus(config-if)# switchport access vlan 12
awplus(config-if)#
awplus# show vlan 12
Here is an example on how to configure the switch as the command switch
of the enhanced stack. The example creates a common VLAN and
assigns it a management IP address. Here are the specifications for this
command switch:
 Common VLAN name: Tech_Support
 VID: 12
 Untagged VLAN ports: 18 to 22
 Management IP address and subnet mask: 149.22.88.5 and
255.255.255.0
 Default gateway: 149.22.88.27
(A default gateway is optional, but including it allows you to manage the
switch and the enhanced stack from remote workstations that are not in
the same subnet as the command switch.)
1. This step creates the common VLAN.
end
AT-8100 Switch Command Line User's Guide
Enter the Privileged Exec mode
from the User Exec mode.
Enter the Global Configuration
mode.
From the Global Configuration
mode, enter the VLAN Interface
mode.
Create the Tech_Support VLAN
and assign it the VID 12.
Return to the Global Configuration
mode.
Enter the Port Interface mode for
ports 18 to 22.
Designate the ports as untagged
ports.
Add the ports to the Tech_Support
VLAN.
Return to the Privileged Exec
mode.
Verify the new VLAN.
411