Reboot Estack Member - Allied Telesis AT-8100L/8 User Manual

Chapter 24: Enhanced Stacking Commands

REBOOT ESTACK MEMBER

438
Syntax
reboot estack member
Parameters
id_number
Specifies the enhanced stack ID number of a switch. The number
is displayed with "SHOW ESTACK REMOTELIST" on page 443.
You may specify the ID number of only one switch.
all
Specifies all of the switches of the enhanced stack, except the
command switch.
Mode
Global Configuration mode
Description
Use this command from the command stack of an enhanced switch to
reboot member switches. You may reboot individual member switches or
all of the member switches of a stack. You must perform "SHOW ESTACK
REMOTELIST" on page 443 prior to this command to determine the ID
numbers of the switches.
Caution
A switch does not forward network traffic when it reboots and
initializes its management software. Some network traffic may be
lost. The reset can take from 10 seconds to two minutes, depending
on the number and complexity of the commands in the active boot
configuration file.
Note
Any configuration changes that are not saved to the active
configuration file with the WRITE command are discarded when a
switch reboots.
Caution
This command does not display a confirmation prompt. A member
switch resets as soon as you enter the command.
id_number
| all