Table of Contents
Advertisement
Chapter 50: Static Port Trunk Commands
NO STATIC-CHANNEL-GROUP
734
Syntax
no static-channel-group
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove ports from static port trunks and to delete
trunks. To delete a trunk, remove all its ports.
Caution
To prevent the formation of loops in your network topology, do not
remove ports from a static port trunk without first disconnecting their
network cable. Network loops can result in broadcast storms that
can adversely affect network performance.
Note
You cannot leave a trunk with just one port. There must be a
minimum of two ports in a trunk.
Example
These commands remove ports 22 and 23 from a static port trunk. If these
are the only ports in the trunk, the trunk is deleted from the switch:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.22-port1.0.23
awplus(config-if)# no static-channel-group
Hide quick links:
Advertisement
Table of Contents
