Line Console 0 Command; Line Vty Command; Policy-Map Command; Class Command - Allied Telesis AT-8100L/8 User Manual

LINE CONSOLE
0 Command
LINE VTY
Command
POLICY-MAP
Command
CLASS
Command
You use this command to move from the Global Configuration mode to the
Console Line mode to set the management session timer and to activate
or deactivate remote authentication for local management sessions. The
mode is also used to set the baud rate of the terminal port. The format of
the command is:
line console 0
awplus(config)# line console 0
awplus(config-line)#
Figure 5. LINE CONSOLE Command
You use this command to move from the Global Configuration mode to the
Virtual Terminal Line mode to set the management session timer and to
activate or deactivate remote authentication of manager accounts. The
format of the command is:
line_id
line vty
The range of the LINE_ID parameter is 0 to 9. For information on the VTY
lines, refer to "VTY Lines" on page 73. This example enters the Virtual
Terminal Line mode for VTY line 2:
awplus(config)# line vty 2
awplus(config-line)#
You use this command to move from the Global Configuration mode to the
Policy Map mode where flow groups for Quality of Service policies are
mapped to traffic classes. The format of the command is:
policy-map id_number
This example enters the Policy Map mode for the traffic class with the ID
number 1:
awplus(config)# policy-map 1
awplus(config-pmap)#
Figure 7. POLICY-MAP Command
You use this command to move from the Policy Map mode to the Class
mode, to add flow groups to traffic classes for Quality of Service policies.
The format of the command is:
id_number
class
Figure 6. LINE VTY Command
AT-8100 Switch Command Line User's Guide
57