No Group-Link-Control Downstream - Allied Telesis AT-8100L/8 User Manual

NO GROUP-LINK-CONTROL DOWNSTREAM

Syntax
no group-link-control group downstream
Parameter
group_id
Specifies a group ID number. The range is 1 through 8. The group
must already exist.
Mode
Port Interface mode
Description
Use this command to remove downstream ports from groups in group link
control. You may remove more than one port at a time from groups.
Note
Downstream ports that group link control has disabled remain
disabled when removed from a group. To manually activate the
ports, use the NO SHUTDOWN command. For instructions, refer to
"Enabling or Disabling Ports" on page 182 or "NO SHUTDOWN" on
page 218.
Confirmation Command
"SHOW GROUP-LINK-CONTROL" on page 527
Examples
This example removes downstream port 3 from group ID 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# no group-link-control downstream 5
This example removes downstream ports 14 and 15 from group ID 7:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.14,port1.0.15
awplus(config-if)# no group-link-control downstream 7
AT-8100 Switch Command Line User's Guide
group_id
525