Table 63. Show Ip Igmp Snooping Command - Allied Telesis AT-8100L/8 User Manual

The information the command displays is explained in Table 63.

Table 63. SHOW IP IGMP SNOOPING Command

Parameter
IGMP Snooping Configuration
IGMP Snooping Status
Host Topology
Host/Router Timeout
Interval
Maximum IGMP Multicast
Groups
Router Port(s)
Router List
VLAN ID
AT-8100 Switch Command Line User's Guide
Description
The status of IGMP snooping on the
switch. To enable or disable the feature,
refer to "IP IGMP SNOOPING" on
page 607 and "NO IP IGMP SNOOPING"
on page 612, respectively.
The IGMP host node topology on the
switch. The possible topologies are:
singlehost— This is the single-host per
port topology. This topology is appropriate
when there is only one host node per port
on the switch. This is the default setting.
multihost— This is the multiple-host per
port topology. This topology is appropriate
when there is more than one host node
per port on the switch.
To set this parameter, refer to "IP IGMP
STATUS" on page 611.
The amount of time the switch uses to
time out inactive host nodes and multicast
routers. To set this parameter, refer to "IP
IGMP QUERIER-TIMEOUT" on
page 606.
The maximum number of multicast groups
the switch supports. To set this parameter,
refer to "IP IGMP LIMIT" on page 605.
The ports connected to multicast routers.
The switch can learn the router ports
automatically or you can assign them
manually. To assign the ports manually,
refer to "IP IGMP SNOOPING
MROUTER" on page 610.
The ID numbers of the VLANs of the
router ports.
615