No Power-Inline Allow-Legacy; Table 23. Power Over Ethernet Commands - Allied Telesis AT-8100L/8 User Manual

Chapter 12: Power Over Ethernet Commands

NO POWER-INLINE ALLOW-LEGACY

Syntax
no power-inline allow-legacy
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure the ports to deny power to legacy PDs.
Legacy PDs are PoE devices that were designed before the IEEE 802.3af
and IEEE 802.3at PoE standards were finalized. This is the default setting
for the ports.
Confirmation Command
"SHOW POWER-INLINE INTERFACE DETAIL" on page 288
Example
This example configures ports 1 to 12 to deny power to legacy PDs:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.12
awplus(config-if)# no power-inline allow-legacy
266