No Switchport Block Egress-Multicast - Allied Telesis AT-8100L/8 User Manual

Chapter 33: Multicast Commands

NO SWITCHPORT BLOCK EGRESS-MULTICAST

Syntax
no switchport block egress-multicast
Parameters
None
Mode
Port Interface mode
Description
Use this command to resume forwarding of egress multicast packets on
ports. By default, this is the default setting on all of the ports on the switch.
Confirmation Command
"SHOW INTERFACE" on page 228
Example
This example resumes forwarding of egress multicast packets on port 19:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.19
awplus(config-if)# no switchport block egress-multicast
530