Configuring The Feature; Configuring One Querier; Table 66. Igmp Snooping Querier Commands; Table 67. Configuring One Querier - Allied Telesis AT-8100L/8 User Manual

Configuring the Feature

To
Activate IGMP snooping querier
Deactivate IGMP snooping querier
Set the interval at which IGMP general
query messages are transmitted.
Display the status of IGMP snooping
querier.
Configuring One
Querier
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp snooping
awplus(config)# interface vlan1
awplus(config-if)# ip address
149.123.48.2/24
awplus(config-if)# ip igmp snooping
querier
This section lists the IGMP snooping querier commands and describes
how to configure one querier as well as multiple queriers. See the
following procedures:
 "Configuring One Querier" on page 623
 "Configuring Multiple Queriers" on page 624
Table 66 lists the IGMP snooping querier commands.

Table 66. IGMP Snooping Querier Commands

IP IGMP SNOOPING QUERIER
NO IP IGMP SNOOPING QUERIER
IP IGMP QUERY-INTERVAL interval
SHOW IP IGMP INTERFACE vlanid
This example configures switch 1 as shown in Figure 122 on page 619,
with an additional step for changing the query interval.

Table 67. Configuring One Querier

Command
AT-8100 Switch Command Line User's Guide
Use This Command
Description
Enter the Privileged Executive mode from
the User Executive mode.
Enter the Global Configuration mode.
Activate IGMP snooping on the switch.
(The default setting for IGMP snooping is
disabled.)
Enter the VLAN Interface mode for the
Default VLAN.
Assign the VLAN the IP address
149.123.48.2/24.
Activate IGMP snooping querier on the
VLAN.
Range
none
none
2 to 18000
seconds
none
623