Link-Flap Duration - Allied Telesis AT-8100L/8 User Manual

Chapter 26: Link-flap Protection Commands

LINK-FLAP DURATION

454
Syntax
link-flap duration <20 - 65535>
Parameters
duration
Indicates the time period that defines a link flap event. The range is
20 to 65535 seconds. The default is 60 seconds.
Mode
Global Configuration mode
Description
Use this command to specify the time period the switch uses to determine
whether a port has experienced a link flap event. A link flap event occurs
on a port when its link state changes a defined number of times in a
defined period of time. The number of link state changes, referred to as
the rate, is set with "LINK-FLAP RATE" on page 456. The duration is set
with this command.
Confirmation Command
"SHOW LINK-FLAP" on page 458
Example
This example sets the link-flap duration to two minutes:
awplus> enable
awplus# configure terminal
awplus(config)# link-flap duration 120