No Boot Config-File - Allied Telesis AT-8100L/8 User Manual

NO BOOT CONFIG-FILE

Syntax
no boot config-file
Parameter
None
Mode
Global Configuration mode
Description
Use this command to configure the switch with the settings in the default
BOOT.CFG file.
Caution
This command causes the switch to reset. It does not forward
network traffic while it initializes the management software. Some
network packets may be lost.
After the switch finishes initializing its management software, it uses the
BOOT.CFG file to configure its parameter settings. To overwrite the
settings in the active boot configuration file with the switch's current
settings, enter the WRITE or COPY RUNNING-CONFIG STARTUP-
CONFIG command in the Privileged Exec mode.
This command does not return the switch to its default settings if, at some
earlier time, you used the BOOT.CFG file as the activate boot
configuration file on the switch. To restore the default settings to the
switch, refer to "ERASE STARTUP-CONFIG" on page 564.
Example
This example configures the switch with the settings in the default
BOOT.CFG file:
awplus> enable
awplus# configure terminal
awplus(config)# no boot config-file
AT-8100 Switch Command Line User's Guide
565