No Group-Link-Control Upstream - Allied Telesis AT-8100L/8 User Manual

Chapter 32: Group Link Control Commands

NO GROUP-LINK-CONTROL UPSTREAM

526
Syntax
no group-link-control upstream
Parameter
group_id
Specifies a group ID number. The range is 1 through 8.
Mode
Port Interface mode
Description
Use this command to remove upstream ports from groups.
Note
Removing all of the upstream ports from a group disables the
downstream ports.
Confirmation Command
"SHOW GROUP-LINK-CONTROL" on page 527
Examples
This example removes upstream port 15 from group ID 3:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15
awplus(config-if)# no group-link-control upstream 3
This example removes upstream ports 12 and 13 from group ID 8:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.12-port1.0.13
awplus(config-if)# no group-link-control upstream 8
group_id