Arp Security Violation - Allied Telesis AT-8100L/8 User Manual

Chapter 44: DHCP Snooping Commands

ARP SECURITY VIOLATION

636
Syntax
arp security violation
Parameters
violation
Specifies one of the following actions if an ARP security violation
occurs:
link-down: Disables the port.
log: Generates a log message. Use the SHOW LOG command
to display these messages. See "NO LOG BUFFERED" on
page 693.
trap: Generates an SNMP notification or trap. To make this
parameter active, configure SNMP and enable DHCP snooping
notifications with the SNMP-SERVER ENABLE TRAP
command. See "SNMP-SERVER ENABLE TRAP" on
page 1166. Notifications are limited to one per second and to
one per source MAC and violation.
Mode
Port Interface mode
Description
Use this command to set the an action if an ARP security violation occurs
on a port.
Use the no version of this command, NO ARP SECURITY VIOLATION
command, to cancel the ARP security violation action previously
configured.
Confirmation Command
"NO LOG BUFFERED" on page 693
"SHOW RUNNING-CONFIG" on page 164
link-down|log|trap