Creating Syslog Server Definitions; Table 83. Event Message Severity Levels; Table 84. Program Abbreviations - Allied Telesis AT-8100L/8 User Manual

Creating Syslog Server Definitions

To configure the switch to send event messages to a syslog server, create
a syslog server definition with the LOG HOST command in the Global
Configuration mode. Here is the format of the command:
ipaddress
log host
This command creates just one definition at a time.
The IPADDRESS parameter is the IP address of a syslog server you want
to receive event messages. You can specify just one address.
The LEVEL parameter specifies the minimal severity level of the events to
transmit to the server. The switch supports the four severity levels in
Table 83. Messages of the specified level and all levels below it are
transmitted to the server. For example, specifying level 4 for a syslog
server definition causes the switch to transmit levels 0 and 4 messages. If
you omit this parameter, messages of all severity levels are sent.

Table 83. Event Message Severity Levels

Value Severity Level
0 Emergency
4 Warning
6 Informational
7 Debug
The PROGRAM parameter is used to restrict the transmitted messages to
just those that are generated by particular programs on the switch. You
designate the programs by entering their abbreviations, listed in Table 84.

Table 84. Program Abbreviations

Abbreviation
ALL
ACL
CFG
CLASSIFIER
CLI
level
[level ] [program
Switch operation is severely impaired.
An issue may require manager attention.
Useful information that can be ignored
during normal operation.
Messages intended for technical support
and software development.
Program
All features
Port access control list
Switch configuration
Classifiers used by ACL and QoS
Command line interface commands
AT-8100 Switch Command Line User's Guide
program
]
Description
709