Chapter 10 : Port Parameter Commands - Allied Telesis AT-8100L/8 User Manual

Chapter 10
Port Parameter Commands
Command
"BACKPRESSURE" on page 200
"BPLIMIT" on page 202
"CLEAR PORT COUNTER" on
page 203
"DESCRIPTION" on page 204
"DUPLEX" on page 206
"EGRESS-RATE-LIMIT" on page 208
"FCTRLLIMIT" on page 209
"FLOWCONTROL" on page 210
"HOLBPLIMIT" on page 213
"NO EGRESS-RATE-LIMIT" on
page 216
"NO FLOWCONTROL" on page 217
"NO SHUTDOWN" on page 218
"NO SNMP TRAP LINK-STATUS" on
page 219
The port parameter commands are summarized in Table 11.
Table 11. Port Parameter Commands
Mode
Port Interface
Port Interface
User Exec and
Privileged Exec
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Description
Enables or disables backpressure on
ports that are operating in half-duplex
mode.
Specifies threshold levels for
backpressure on ports.
Clears the packet counters.
Adds port descriptions.
Configures the duplex modes.
Sets a limit on the amount of traffic
that can be transmitted per second
from the port.
Specifies threshold levels for flow
control.
Enables or disables flow control on
ports that are operating in full-duplex
mode.
Specifies a threshold for head of line
blocking events.
Disables egress rate limiting on the
ports.
Disables flow control on ports.
Activates disabled ports so that they
resume forwarding network traffic
again.
Deactivates link traps.
197