Power-Inline Allow-Legacy - Allied Telesis AT-8100L/8 User Manual

Chapter 12: Power Over Ethernet Commands

POWER-INLINE ALLOW-LEGACY

Syntax
power-inline allow-legacy
Parameters
None
Mode
Port Interface mode
Description
Use this command to configure the ports to support legacy PDs. Legacy
PDs are PoE devices that were designed before the IEEE 802.3af and
IEEE 802.3at PoE standards were finalized. The default setting is no
support for legacy PDs.
Confirmation Commands
"SHOW POWER-INLINE INTERFACE DETAIL" on page 288
Example
This example configures ports 1 to 6 to support legacy PDs:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.6
awplus(config-if)# power-inline allow-legacy
274