Displaying An Ipv6 Management Address And Default Gateway - Allied Telesis AT-8100L/8 User Manual

Displaying an
IPv6
Management
Address and
Default Gateway
IPv6 Routing Table
Codes: C - connected, S - static
S
C
Interface IPv6-Address
VLAN3-0 832a:5821:b34a:0:0:0:187:95a/64
There are two commands for displaying a management IPv6 address and
default gateway. If the switch has both an IPv6 address and default
gateway, you can display both of them with the SHOW IPV6 ROUTE
command, in the Privileged Exec mode, as shown here:
awplus# show ipv6 route
Here is an example of the information. The default route is displayed first,
followed by the management address.
0:0:0:0:0:0:0:0/0 via 832a:5821:b34a:0:0:0:187:14, vlan4-0
832a:5821:b34a:0:0:0:187:95a/64 via ::, vlan4-0
Figure 70. SHOW IPV6 ROUTE Command
Another way to display just the management address is with the SHOW
IPV6 INTERFACE command, shown here:
awplus# show ipv6 interface
Here is an example of the information from the command.
Figure 71. SHOW IPV6 INTERFACE Command
The columns are defined in Table 31 on page 329.
AT-8100 Switch Command Line User's Guide
Status Protocol
admin up down
305