Saving Your Changes - Allied Telesis AT-8100L/8 User Manual

Chapter 2: Starting a Management Session
awplus(config-if)# switchport access vlan 5
awplus(config-if)# exit
awplus(config)# interface vlan5
awplus(config-if)# ip address dhcp
awplus(config-if)# end
awplus# show ip interface
awplus# show ip route
Saving Your
Changes
78
Table 4. Adding a Management IP Address: Example 2
To permanently save your changes in the active boot configuration file,
use the WRITE command in the Privileged Exec mode:
awplus# write
You can also update the active configuration file with the COPY
RUNNING-CONFIG STARTUP-CONFIG command, also located in the
Global Configuration mode. It is just more to type.
Add the ports as untagged ports to the
VLAN with the SWITCHPORT ACCESS
VLAN command.
Return to the Global Configuration mode.
Use the INTERFACE VLAN command to
move to the VLAN Interface mode of
VLAN 5.
Activate the DHCP client on the switch
with the IP ADDRESS DHCP command.
Return to the Global Configuration mode.
Verify the management IP address on the
switch.
Verify the new management IPv4 address
and default gateway.